1 Pair of preamp RCA outputs. Protection against speaker shorts, overcurrent, DC offset, under-voltage, over-voltage, and reverse polarity.Input sensitivity selection switch (200mV - 8V). Heavy duty aluminum alloy heatsink for extreme heat dissipation.
Variable low-pass filter (30-250 Hz, 24 dB/octave). Subsonic Filter (12 dB at 24 Hz). Two pole slide system for raising and lowering blade for a more efficient and smoother adjustment of the blade depth. Signal to Noise Ratio: >65dB. THD at 1 Watts, 4 Ohms.
Fuses: 200A external fuse required (not included). Dimensions: 9-1/4" x 2-1/2" x 14-1/2.Screws, bass knobs, plastic coverings, protective films, etc. All DOA (Dead on Arrival)/ Defective items must be reported within 48 hours after receiving the item. When ordering for a Car Alarm Replacement remote make sure you are ordering the correct one or give us a call to check if it is compatible with your Car/ Car alarm. Physical damage: Item is scratched, torn, wet, burned, blown, signs of misuse, and faulty installation DEFECTIVE or non DEFECTIVE. Factory sealed items: If its opened and tampered except for certain items. The item "ORION XTR2500.1Dz XTR 1-CHANNEL MONO BLOCK CLASS D CAR AMP AMPLIFIER 2500W RMS" is in sale since Friday, January 26, 2018. This item is in the category "Consumer Electronics\Vehicle Electronics & GPS\Car Audio\Car Amplifiers". The seller is "discountcentralonline" and is located in Los Angeles, California. This item can be shipped to United States.